FIC VA-502 Manual page 61

PM Control by APM
The option No allows the BIOS to ignore the APM (Advanced Power
Management) specification. Selecting Yes will allow the BIOS wait for
APM's prompt before it enters Doze mode, Standby mode, or Suspend
mode. If the APM is installed, it will prompt the BIOS to set the system into
power saving mode when all tasks are done.
The options are: No, Yes (Default).
Video Off Option
This feature provides the selections of the video display power saving mode.
The option Suspend - Off allows the video display to go blank if the system
enters Suspend mode. The option All Modes - Off allows the video display
to go blank if the system enters Doze mode or Suspend mode. The option
Always On allows the video display to stay in Standby mode even when the
system enters Doze or Suspend mode.
The options are: Suspend - Off (Default), All Modes - Off, Always On.
Video Off Method
The option V/H SYNC+Blank allows the BIOS to blank off screen display
by turning off the V-Sync and H-Sync signals sent from add-on VGA card.
DPMS Supported allows the BIOS to blank off screen display by your add-
on VGA card which supports DPMS (Display Power Management Signaling
function). Blank Screen allows the BIOS to blank off screen display by
turning off the red-green-blue signals.
The options are: V/H SYNC+Blank, DPMS Support (Default), Blank
Screen.
MODEM Use IRQ
This feature allows you to select the IRQ# to meet your modem's IRQ#.
The options are: NA, 3, 4, 5, 7, 9, 10, 11.
HDD Power Management
Selecting Disabled will turn off the hard disk drive (HDD) motor. Selecting
1 Min..15Min allows you to define the HDD idle time before the HDD
enters Power Saving Mode. The option When Suspend lets the BIOS turn
the HDD motor off when the system is in Suspend mode.
The options 1 Min..15Min and When Suspend will not work concurrently.
When HDD is in Power Saving Mode, any access to the HDD will wake the
HDD up.
The options are: Disabled (Default), 1 Min..15 Min, When Suspend.
Award BIOS Setup
45