Canon Color imageCLASS MF9220Cdn Basic Operation Manual page 492

Error Code
#0752
– The SMTP server name for e-mail or I-fax is not
correct.
– The domain name or e-mail address may not
be set.
– The mail server is not functioning.
– The network is down.
– While an e-mail message were being sent in
color, some error occurred.
#0753
A TCP/IP error occurred while sending documents
to a file server, or sending an e-mail message.
(Socket, Select error, etc.)
#0755
– You cannot send jobs because TCP/IP is not
functioning correctly.
– The IP address is not set.
– When the machine was turned ON, an IP
address was not assigned to the machine by
the DHCP, RARP, or BOOTP server.
Description Action
– Start the Remote UI and make sure that the
SMTP Server in E-mail/I-Fax Settings under
Network Settings matches the SMTP server
address you checked in "Network Settings," in
the e-Manual.
– Start the Remote UI and make sure that
Domain Name in TCP/IP Settings under
Network Settings is set correctly.
– Start the Remote UI and make sure that E-mail
Address in E-mail/I-Fax Settings under Network
Settings is set correctly.
– Ask the network administrator to check that
the mail server is operating properly.
– Ask the network administrator to check that
the network is operating properly.
– Try sending several times. If the error persists,
ask the network administrator to check that the
network is operating properly.
– Check that the network cable is properly
connected between the machine and your
computer.
– Check that the <SMB Settings> is set to <On>.
– Check that the <Host Name> of the file server
destination is set correctly.
– Check that the <Workgroup Name> is set
correctly.
– Set <Use LM Announce> to <On>.
– Check the settings in Windows Firewall.
– If the machine still does not operate normally,
turn the main power OFF, and then back ON.
– Check <TCP/IP Settings> in <Network
Settings> in <System Management Set> (from
the Additional Functions screen).
– Check <TCP/IP Settings> in <Network
Settings> in <System Management Set> (from
the Additional Functions screen).
– After the machine is turned ON,
communication with a network will not start
until the time specified in <Startup Time
Settings> in <Network Settings> in <System
Management Set> (from the Additional
Functions screen) elapses. Wait a few
moments, and then try sending again.
Error Codes
12-37