Canon imagePROGRAF iPF8300 Basic Guide No.2 Basic Manual page 49

Error Message
Cannot feed paper.
Cannot cut paper.
Cannot detect papr
Rel lever is in wrong position.
Cause
A paper jam occurred in the printer
during printing.
There are sheets left on the
Ejection Guide .
There is a foreign object by the
Output Tray , obstructing the
Cutter Unit .
You are not using the printer under
the recommended environmental
conditions for the paper.
You are using paper that is not
compatible with automatic cutting.
In other cases, the Cutter Unit
may be damaged.
The printer could not detect the
paper.
The Release Lever is up.
49
Corrective Action
1. Lift the Release Lever and remove the jammed
paper.
(→ , If Roll Paper Jams)
(→ , If a Sheet Jams)
2. Load paper.
3. Lower the Release Lever .
4. If Not finished printing. Finish printing
remaining jobs? is shown on the Display Screen ,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
(→ , Loading Rolls in the Printer)
(→ , Loading Sheets in the Printer)
1. Lift the Release Lever and remove the paper.
2. Load paper.
3. Lower the Release Lever .
4. If Not finished printing. Finish printing
remaining jobs? is shown on the Display Screen ,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
(→ , Loading Rolls in the Printer)
1. Lift the Top Cover and remove the foreign object.
2. If Not finished printing. Finish printing
remaining jobs? is shown on the Display Screen ,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
Use the printer only where the recommended
environmental conditions for the paper are met.
Note that various environmental conditions are
recommended for various types of paper. For details
on the recommended environmental conditions, see
the Paper Reference Guide .
(→"Types of Paper," User Manual)
1. Specify Manual as the cutting method and use
scissors or a cutting tool to cut the roll.
(→"Specifying the Cutting Method for Rolls," User
Manual)
For information about paper that is compatible with
automatic cutting, see the Paper Reference Guide .
(→"Types of Paper," User Manual)
2. Lift the Release Lever and remove the paper.
Contact your Canon dealer for assistance.
Reload the paper as follows.
1. Press the OK button and remove the paper.
2. Reload the paper.
(→ , Loading Sheets in the Printer)
(→ , Loading Rolls in the Printer)
Lower the Release Lever .
If the error occurs again, turn off the printer and wait a
while before restoring power.
Error Messages