Canon imagePROGRAF iPF8300 Basic Guide No.2 Basic Manual page 42

Error Messages
Error Message
The mail box is full.
Mail box nearly full.
Mail box full. Delete unwanted
data
Rewinding error.
Turn on the media take-up unit.
Media take-up unit ready.
Multi-sensor error
Cause
There is no more space on the
printer's hard disk.
The free hard disk space left for
personal boxes in the printer's
hard disk does not have 1 GB,
combined.
100 jobs are stored in the personal
box.
There is some foreign object near
the Media Take-up Unit sensor
and the roll cannot be detected.
The Media Take-up Unit sensor
is soiled and the roll cannot be
detected.
The roll is out of range of detection
by the Media Take-up Unit
sensor.
The Media Take-up Unit sensor is
damaged.
A paper jam has occurred and the
roll cannot be rewound.
The Media Take-up Unit was off
when you selected Enable for
Take-up Reel .
The Take-up Reel setting in
the printer Set./Adj. Menu was
changed from Enable to Disable ,
but a print job was received before
the roll was removed.
Direct sunlight or strong lighting
may be shining on the printer and
causing the sensor to malfunction.
The performance of a sensor
inside the printer may be impaired.
Corrective Action
Press the Stop button and stop printing.
Delete print jobs from the queue.
(→"Managing the Job Queue (Deleting or Preempting
Other Jobs)," User Manual)
Delete unneeded jobs stored in personal boxes (box
numbers in the range 01–29).
(→"Deleting Saved Jobs," User Manual)
Delete unneeded jobs stored in personal boxes.
(→"Deleting Saved Jobs," User Manual)
Delete unneeded jobs stored in personal boxes.
(→"Deleting Saved Jobs," User Manual)
Remove the foreign object near the sensor.
Wipe the sensor with a dry cloth to clean it.
Reload the roll.
(→ , Loading Rolls in the Printer)
Contact your Canon dealer for assistance.
Remove the paper from the Media Take-up Unit .
Press the OK button to clear the error.
Turn on the Media Take-up Unit .
Press ▲ or ▼ to select Stop Printing , and then press
the OK button to stop printing.
The mode switches from take-up mode to regular
mode after you change the Take-up Reel setting
in the Set./Adj. Menu from Enable to Disable and
lift the Release Lever to remove a roll, or after you
execute Paper Cutting .
Press ▲ or ▼ to select Print , and then press the OK
button to resume printing.
Take steps to ensure the printer is not used when
exposed to direct sunlight or strong lighting.
Contact your Canon dealer for assistance.
42