PDQ 6300 Installation Instruction

CVR EXIT INSTALLATION INSTRUCTION
6300/6400C & CF DEVICES
2. ASSEMBLE RODS &
LATCHES
 Thread CVR linkage into each rod to
approximate middle of threads
Steel/Wood Door – Attach mounting
Aluminum Door –
THRESHOLD NOTE:
When using ½" threshold, move bottom rod
attachment pin to upper hole in bottom rod.
PIN SLOT
brackets as shown
Continue to next step
TO TOP OF L BRACKET
OR TOP OF LATCH BODY
TOP ROD
BOTTOM ROD
SLOT
CVR
LINKAGE
BOTTOM
ROD HOLES
3. ADJUST RODS
When measuring, be sure length is in the
collapsed pin position as shown.
TOP ROD LENGTH: Measure from top
of door to device centerline. Subtract 2 1/
4".
Typical 7' Door: 41 5/8"
(43 7/8" - 2 1/4" = 41 5/8")
BOTTOM ROD LENGTH: 37" if device
is installed 40" above the finished floor.
PIN
1
Phone: 833-2-PDQTEC | www.pdqlocks.com
1. PREPARE DOOR
 Prepare door according to
template.
 Refer to trim template if
installing trim.
MOUNTING
BRACKETS
639409 Rev1 – 6/15/22
CVR
LINKAGE