Advertisement
Quick Links
6300M/MF EXIT INSTALLATION INSTRUCTION
MORTISE DEVICE
LATCH BOLT
HEAD SCREW
LATCH BOLT
HEAD
INSIDE
LEFT HAND REVERSE
(LHR)
OUTSIDE
2. DOOR PREPARATION
Prepare the door for the mortise lock
using the 6300M/MF template in box.
Refer to trim template if installing trim.
Install the mortise case and secure using
two (2) #12-24 combo screws supplied in
the hardware kit.
LATCH BOLT
HEAD SCREW
LATCH BOLT
HEAD
INSIDE
RIGHT HAND REVERSE
(RHR)
OUTSIDE
MORTISE
DRIVER
LOCATING
STUD
THREADED
INSERT
Phone: 833-2-PDQTEC | www.pdqlocks.com
1. MORTISE HANDING
To re-hand mortise case, remove latch
bolt screw as shown.
Orient the latch bolt head to match
handing.
Reinsert and tighten the latch bolt screw.
3. PREPARE DEVICE
Install locating stud on lower threaded
insert as determined by handing.
Rotate lower mortise driver as shown
until it stops. Make sure when installing
that mortise driver remains in this
position.
1
639415 Rev0 – 4/22/21
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for PDQ 6300M/MF
Summary of Contents for PDQ 6300M/MF
- Page 1 OUTSIDE 2. DOOR PREPARATION Prepare the door for the mortise lock using the 6300M/MF template in box. Refer to trim template if installing trim. Install the mortise case and secure using two (2) #12-24 combo screws supplied in the hardware kit.
- Page 2 6300M/MF EXIT INSTALLATION INSTRUCTION MORTISE DEVICE 4. SIZE DEVICE Standard lengths are for 36" or 48" door. Device must be cut for other lengths. Mark length with tape – length equals device size minus desired door size (for 30"...
- Page 3 6300M/MF EXIT INSTALLATION INSTRUCTION MORTISE DEVICE Phone: 833-2-PDQTEC | www.pdqlocks.com 7. INSTALL END CAP Slide end cap into rail. Ensure rail is level. Mark the centers of the slots. Remove end cap then drill holes using the chart from Step 3.
Need help?
Do you have a question about the 6300M/MF and is the answer not in the manual?
Questions and answers