Trim and Tilt
Trim and Tilt Servicing
Tilt Piston Removal
Use Tilt Cylinder End Cap Remover/Installer,
P/N 326485, or Universal Spanner Wrench,
P/N 912084, and a breaker bar, to unscrew the tilt
rod end cap.
Drain the fluid from above the piston.
Slowly pull the piston out with a rag wrapped
around the rod and the top of the cylinder. Drain
the remaining fluid from the cylinder.
308
Inspect the bore of the tilt cylinder for excessive
scoring. If the bore of the tilt cylinder is scored or
damaged, the hydraulic assembly must be
replaced.
Clamp the rod eye tightly in a soft jaw vise.
41788
Remove the nut from the piston end of the rod.
41789
1. End cap
41765
1
41767
41781