Table of Contents
Advertisement
Routine Service
Lubrication
Lubrication
Steering System
WARNING
Failure to re-grease as recommended could
result in steering system corrosion. Corro-
sion can affect steering effort, making opera-
tor control difficult.
Grease the stainless steel output end of the steer-
ing cable with Triple-Guard grease.
Use an appropriate cleaning solvent to remove
corrosion and dirt from output end of cable prior to
coating it with grease. Make sure wiper nut is
installed and not damaged.
2
1. Steering cable
2. Wiper nut
Tilt Tube
Lubricate the tilt tube grease fittings with Triple-
Guard grease.
1
1. Tilt tube fittings
38
1
DR29546
1
DR38798
Swivel Bracket and Trailering
Bracket
Lubricate the swivel bracket with Triple-Guard
grease.
Apply grease until the grease begins to flow from
the upper or lower swivel bracket areas.
Coat the pivot points of the trailering bracket with
Triple-Guard grease.
1. Grease fitting
2. Pivot points
3. Lower swivel bracket area
Throttle and Shift Linkage
Disconnect the battery cables at the battery.
Remove cable trunnion cover. Carefully, remove
throttle and shift cables from trunnion block.
IMPORTANT:
DO NOT disturb cable trunnion
adjustments.
Shift
remote
control
TLE/REVERSE position to fully extend the plastic
casing guides.
Apply Triple-Guard grease to:
•
Pivot and slide area of the shift interrupt switch
bracket
•
Cable attachment pins of both the throttle and
shift levers
1
3
2
2
DR5073
into
FULL
THROT-
Advertisement
Chapters
Table of Contents
Troubleshooting
