Removal Of The Piston 活塞的拆卸 - BRP ROTAX 125 MAXevo Repair Manual

REMOVAL OF THE PISTON 活塞的拆卸
概要
General See
In order to protect the piston pin circlip from unintentional loss, a suitable clean cloth
should be used to cover the open cylinder bore in the crankcase.
為防止活塞銷卡環意外遺失，應使用合適且乾淨布蓋住曲軸箱中敞開的汽缸開口。
Always support the piston with the hand in order to avoid a bending moment or damage
of the surface. 過程中請始終用手支撐活塞，以避免受到彎曲力或表面損壞
Special tools 特殊工具 The following special tools and equipment are required: 需要以下的特殊工具或設備
Part no. 料號
676035
976380
Instructions 指引 Proceed as follows to remove the piston: 依以下步驟拆解活塞
1. Pull out the circlip (2) with the circlip puller (1). Use safety goggles to protect your eyes!
使用活塞銷卡環拉出器（下圖1號件）將活塞銷卡環拉出，建議使用安全護目鏡保護眼睛
2. Press the piston pin (4) out of the piston with the point of the special tool (3).
使用特殊工具（下圖3號件）壓出活塞銷（下圖4號件）
Effectivity: 125 MAX evo, Junior MAX
evo, Mini MAX evo, Micro MAX evo
Edition - February 01 2018 /Rev. 0
REPAIR MANUAL修復手冊
活塞.
Figure圖: piston
Description 說明
Insertion tool 活塞銷壓入工具
Circlip puller 活塞銷卡環 拉出器
BRP-Rotax
ATTENTION 注意
ATTENTION 注意
Field of application 運用的部位
Piston 活塞
Circlip 活塞銷卡環
Chapter 4
Page 11