Physical Installation - Wahlberg Roll Down Manual

Physical installation

WARNING! The Roll Down must be either fastened to a flat surface such as a roof or clamped to
a truss or similar structure in such a way that the mounting clamp points upwards. Do not apply
power to the product if it is not securely fastened.
WARNING! The supporting surface must be hard and flat. Fasten the product securely.
WARNING! Use only the supplied rigging clamps.
Fastening the product to a flat surface
The Roll Down can be fastened to flat surface such as a roof. Check that the surface can support
at least 10 times the weight of all products and equipment to be installed on it.
Mounting the product on a truss
The Roll Down can be clamped to a truss or similar rigging structure.
To clamp a product to a truss:
1. Check that the rigging clamps are undamaged and that the rigging structure can support at
least 10 times the combined weight of all products and equipment to be installed on it.
2. Block access under the work area. Working from a stable platform, hang the product on the
truss with the mounting clamp upwards. Tighten the rigging clamp.
3. Use the supplied 2 slim couplers sitting on the top plate. It is important to use both slim
couplers for mounting because the load is not evenly distributed across the product.
4. Install a suitable safety cables when the product is hanging over-head and verify that it
complies with either EN 60598-2-17:2018 section 17.7.4 or BGV C1/DGUV 17.
Safety Cable
249.805.013 9 Date: 2021-12-09