Wahlberg Roll Down Manual page 11

Mounting the fabric
WARNING! The fabric must be mounted on the tube in a way to ensure that the fabric never can
damage the Roll Down.
WARNING! There should be minimum 1½ round left on the tube when the fabric is rolled all the
way out if it is mounted with the rail.
WARNING! There should be minimum 2 round left on the tube when the fabric is rolled all the
way out if it is mounted with tape.
Mount the fabric in the right position
When mounting the fabric, it is important to move the tube to the desired bottom position before
you start.
Example: If you are mounting a fabric with a length of 4 meters, follow these steps.
1. Set all channels to 0% and enable the motor by setting channel 4 (50-55%).
2. Move the tube to the hard TOP limit with channel 5 (until it stops).
3. Calculate the number of rotations needed for the specific fabric using the formula below.
������������ ���� ������������������(��������������) =
��������������:
4. Move the tube down with channel 6 while counting the number of rotations calculated
above.
(2)
5. Mount the fabric on the tube either with the rail or with tape, see instructions on the next
page for details.
6. Now return to the desired soft TOP position using channel 5.
(5)
249.805.013
400
= �������������� 6½ ������������������
62.8
Until STOP
Add fabric
OR
11
����������ℎ ���� ������������(����)
62.8
# of rotations calculated
(4)
(7)
Soft TOP Limit
Date: 2021-12-09