Table of Contents
Advertisement
Safety functions
The control system ensures that the motor only is powered when:
•
The DMX signal is reliable.
•
The mode, position and speed control are set correctly.
•
The tube position is within the span of the soft and hard limits.
•
No overload.
The Roll Down should only be operated by an experienced DMX-controlled-lighting-desk-operator.
The lighting desk must be programmed according to the manual, so the Roll Down will stop when
the speed is put to 0 %. It is also possible for the user to stop the Roll Down by disconnecting it
from the mains power. After power failure the start position of the Roll Down may need to be
adjusted before the Roll Down can function properly again.
Manual operation of the Roll Down is only intended for installation, service, and tests.
Area of use
WARNING! To reduce the risk of electric shock or injury use indoors only.
WARNING! To reduce the risk of electric shock, do not expose to rain.
The Roll Down is intended for indoor use only. It is designed for lifting and lowering material at
the weight and speed stated in "Technical specifications" on page 4. Any other use of the product
may result in a risk of injury of persons or equipment damage.
Exceeding the load rating may cause failure of the equipment.
Use only the Wahlberg Motion Design approved mounting connectors to secure the load to the
tube. Failure to mount the load securely can result in a risk of injury of persons or equipment
damage.
Do not modify the product. For any modification contact Wahlberg Motion Design.
It is the customer's sole responsibility to comply with any relevant local laws, regulatory
requirements, and restrictions, concerning the use of the product.
Using for the first time
IMPORTANT! The Roll Down must be protected from environmental factors such as physical
shocks and vibration during transportation and storage.
WARNING! Read "Safety Information" on page 2 before installing, powering, operating, or
servicing the Roll Down. Before applying power to the product.
−
Check the Wahlberg Motion Design website at
documentation and technical information about the product. Wahlberg Motion Design user
manual revisions are identified by the revision number in the bottom of each page.
−
Carefully review the "Safety Instructions" on page 2.
−
Check that the local AC mains power source is within the power voltage and frequency ranges.
−
See "Power cables and power plug" on page 14. Install the provided Neutrik powerCON TRUE1
NAC3FX-W-TOP power connector on a suitable power cable. If using the power from a mains
power outlet, install a suitable power plug on the power cable.
249.805.013
www.wahlberg.dk
7
for the most recent
Date: 2021-12-09
Advertisement
Table of Contents
