Table of Contents
Advertisement
Adjusting procedure
1. Put the Roll Down in manual mode while adjusting the limits.
2. Localise the hard limit switch box, the black box just in front of the fan.
3. Loosen the two screws holding the lid.
4. Loosen the middle screw.
5. Hard BOTTOM limit is adjusted by turning the screw with a 1 next to it.
6. The hard TOP limit is adjusted by turning the screw with a 2 next to it.
7. When adjustments are done tighten the middle screw again.
8. Mount the lid with the two screws again.
The hard limits are factory set to have a travel length of 18 m.
249.805.013
27
Date: 2021-12-09
Advertisement
Table of Contents
