Replacing Batteries - Valor MADRONA MF28JN Homeowner's Manual

Replacing batteries

WARNING
Do not attempt to access the batteries
while the stove is hot! Let the stove cool
fi rst before touching it!
Caution
Do not use a screwdriver or other metallic
object to remove the batteries from the battery
holder or the handset! This could cause a short
circuit.
Low batteries signals:
• Handset: battery icon on display shows 1 lit bar
• Holder: frequent beeps for 3 seconds when valve
motor turns.
BEFORE changing the batteries, turn the stove off
(including pilot) and let it cool.
The stove uses four 1.5 V AA alkaline batteries in a
separate battery holder located next to the receiver
under the firebox and one 9V alkaline battery in its
handset. Batteries should last one to two seasons,
depending on usage. Removing the batteries in the
off-season will extend the battery life.
To access the battery holder,
• Madrona Traditional:
and the fret or the front.
• Madrona Modern: open the bottom access panel
under the front.
Stove
Gas Battery
Receiver valve holder
Battery holder located near the controls on
bottom of stove behind access panel/fret
remove the barrier screen
Stove
Gas
Receiver valve
To replace the batteries:
1. Open the bottom access panel or
unhook the front. Be aware that
the cast iron front is very heavy.
2. Locate the battery holder near
the controls under the fi rebox. Pull the battery
holder out.
3. Disconnect the battery holder wire. Do not pull
on the wire!
4. Remove the used batteries from the battery
holder and replace with 4 new AA 1.5V alkaline
batteries. Do not mix new/used batteries.
Caution
Do not put batteries in the receiver as leaking
acid could damage its circuit board.
5. Reconnect the battery holder wire.
6. Reinstall the battery holder near the controls.
Using Handset Wall Holder
Your stove equipment includes a wall
holder to store the handset. If it hasn't been
installed, refer to the instructions in the stove
Installation Manual.
Battery
holder
Battery holder
Remote and wall holder
11