Champion Power Equipment 100386-EU Operator's Manual page 9

100386-EU - 4200 PSI PRESSURE WAShER
1. Before adding fuel and oil, carefully pivot the pressure
washer up and forward so that it rests on the front bumper
housing. Place a piece of cardboard from the packaging or
moving blanket on the ground before tipping forward.
2. Slide the roll pin through the wheel from the outside.
3. Slide the roll pin through the mount point on the frame.
4. Secure with the B-clip.
5. Repeat to attach the second wheel.
6. Add wheel caps to protect the roll pins.
7. Attach the metal support bracket to the back & bottom of
the frame using the M8 x 55mm bolt included. Rubber feet
facing outward. (D)
D
8. Fasten securely with the M8 nut.
9. Insert spray nozzles into proper position on handle shroud.
(E) NOTE: Nozzle size is located on the face of the nozzle
(See image below).
E
9
ASSEMbLY
EN