Table of Contents
Advertisement
Available languages
Available languages
100386-EU - 4200 PSI PRESSURE WAShER
Parts Included
Gun Assembly
Spray Wand (A)...................................................................... 1
Trigger Gun (B) ...................................................................... 1
Quick Connect Nozzles (C) ..................................................... 5
Hoses
50 ft. (15.2 m) High Pressure Hose (D) ................................... 1
4 ft. (1.2 m) Detergent Hose (E) ............................................. 1
Garden Hose Adapter (G) ....................................................... 1
Other
Oil Funnel (F) ......................................................................... 1
D
F
A
b
c
E
G
ASSEMbLY
Your pressure washer requires some assembly. This unit ships
from our factory without oil. It must be properly serviced
with fuel and oil before operation. If you have any questions
regarding the assembly of your pressure washer, call our help
line at 44(0)1942-715-407. Please have your serial number and
model number available.
Remove the Pressure Washer from the
Shipping carton
1. Set the shipping carton on a solid, flat surface.
2. Remove everything from the carton except the pressure
washer.
3. Carefully cut each corner of the box from top to bottom.
Install handle to bottom Frame
1. Line up the handle with the bottom frame.
2. Make sure the handle holes are lined up with the bottom
frame spring button (A). Front face of shroud (decal side)
should face the engine
3. Slide the handle downward on the bottom frame until the
handle contacts the spring buttons. Depress the spring
buttons and slide the handle downward until the buttons
have popped through the holes on the handle frame. A
"click" may sound. (B)
4. Gently pull up on the handle to make sure that two frames
have made a solid connection and that the handle can not
be pulled off without pressing on the spring buttons to
release it.
A
8
ASSEMbLY
A
B
B
Advertisement
Table of Contents
