Champion Power Equipment 100386-EU Operator's Manual page 18

100386-EU - 4200 PSI PRESSURE WAShER
5. Refer to the spark plug types in Specifications when
replacing the plug.
6. Carefully thread the plug into the engine
7. Use the spark plug socket tool (not included), or a
21 mm (13/16 in.) (not included) socket to install the plug.
8. Attach the spark plug wire to the plug.
cleaning the Air Filter
1. Using your fingers, unscrew the thumb screws of the top
holes of the air filter cover.
2. Remove the plastic outer casing.
3. Remove the foam element.
4. Wash in liquid detergent and water. Squeeze thoroughly dry
in a clean cloth.
5. Saturate in clean engine oil.
6. Squeeze in a clean, absorbent cloth to remove all excess
oil.
7. Place the filter in the assembly.
8. Reattach the air filter cover and using your fingers, insert
the thumb screws into the top and bottom holes of the air
filter cover. Screw until tight. Be sure not to over tighten.
cleaning the Spark Arrester
1. Allow the engine to cool completely before servicing the
spark arrester.
2. Remove the four (4) screws holding the cover plate which
retains the end of the spark arrester to the muffler.
3. Remove the spark arrester screen.
4. Carefully remove the carbon deposits from the spark
arrester screen with a wire brush.
5. Replace the spark arrester if it is damaged.
6. Position the spark arrester in the muffler and attach with
the four (4) screws.
Failure to clean the spark arrester will result in degraded
engine performance.
Federal and local laws and administrative requirements
indicate when and where spark arresters are required.
When ordered, spark arresters are required for operation
of this product in National Forest lands. In California, this
product must not be used on any forest-covered land,
brush-covered land, or grass-covered land unless the
engine is equipped with a spark arrester.
Adjusting the Governor
Tampering with the factory set governor will void your
warranty.
The air-fuel mixture is not adjustable. Tampering with the
governor can damage your pressure washer and will void your
warranty. CPE recommends that you contact our service line
at 44(0)1942-715-407 for all other service and/or adjustment
needs.
Maintenance Schedule
Follow the service intervals indicated in the schedule
below. Service your pressure washer more frequently when
operating in adverse conditions. Contact our help line at
44(0)1942-715-407 to locate the nearest Champion Power
Equipment certified service dealer for your maintenance needs.
EVERY 8 HOURS OR DAILY
— Check oil level
— Clean around air intake and muffler
FIRST 5 HOURS
— Change oil
EVERY 50 HOURS OR EVERY SEASON
— Clean air filter
— Change oil if operating under heavy load
or in hot environments
18
MAINTENANcE
cAUTION
NOTIcE

WARNING