Welbilt MERRYCHEF conneX Service & Repair Manual page 75

6 Replacing components
Removing the door assembly
1. Remove the two M4 x10 hex Head
Flange Bolts on the bottom of the door.
4. Unfasten and remove
the four M5 flange locking
nuts & M5 hex head bolts
from the door hinges
7. The door choke is removed by unfastening the sixteen M8 hex nuts. On refitting the door choke, ensure the studs are
positioned correctly in the centre of the hole and not resting on the shoulder of the stud. The nuts should be retightened
diagonally in the following sequence to 2.1 Nm.
8. Wear gloves when removing or refitting insulation pads/mats in the door.
Refitting the door assembly
Follow the steps in the reverse order to refit the door to the oven.
Holding the door squarely against the cavity, the hinge nuts and bolts should be torqued up to 3.5Nm.

Apply Loctite to the door skin bolts and screws, which should then be torqued up to 1Nm.

Check that the door seal firmly meets the cavity frame all the way around once closed. A poor sealing door can

cause issues with the oven's operation.
Check the door switches are correctly adjusted and operating freely.

Merrychef conneX ® service and repair manual
2. Remove the three M3 x12 CSK
Philips Head screws along the top
edge of the door.
5. Open the door and fit the
locking pins in place to prevent
the hinges snapping back.
Back to contents >
3. Slide the door skin off the
door.
6. Slide door off the hinges to
remove.
75