SMART MX Series User Manual page 35

Chapter 4 Connecting computers and other devices
Your organization's installers might have connected cables to the display and run the cables
l
behind a wall or under the floor to a desk or table where you can place your computer.
You can charge devices connected to the USB Type-C receptacle on the font connector panel of
l
SMART Board MX (V2-C and V3) series interactive displays up to 15 W.
You can charge devices connected to the USB Type-C receptacle on the side connector panel of
l
SMART Board MX (V3) series interactive displays up to 65 W (if a module is not installed in the
accessory slot) or up to 30 W (if a module is installed in the accessory slot).
Viewing a connected computer's input
To view the input of a computer connected to a SMART Board MX (V3, V2 or V2-C) series display
1. Connect the computer to the display.
2. Do one of the following:
If iQ is enabled
Tap Input on the Home screen.
OR
Press Input on the remote control.
OR
Press Input on the front control panel.
The display shows thumbnails of the devices that are connected to the display's inputs:
Note
A thumbnail with Touch enabled
device and touch is available.
o A gray thumbnail indicates no device is connected to an input.
o A black thumbnail indicates a device is connected to an input but is in Standby mode.
o A thumbnail showing a preview screen indicates an active device is connected to an input.
3. Tap the computer's thumbnail.
smarttech.com/kb/171554
If iQ is disabled
Press the Home button
on the remote control.
indicates a USB cable is connected between the display and
or the Input button
35