General Safety Instructions - schmersal PSC1-C-10 Series Installation Manual

Installation manual
2.3

General safety instructions

Safety instructions:
•
To prevent injury and damage, only qualified personnel are allowed to work on the device.
Qualified personnel are personnel who have electrical engineering training and who are
familiar with the applicable rules and standards of electrical engineering.
The qualified person must become familiar with the operating instructions
(cf. IEC364, DIN VDE0100).
•
The qualified person must have, as a minimum, detailed knowledge of national health and
safety regulations
•
The usage of the devices is to be limited to their intended usage as per the list given above.
The values in the data listed in section "3.2. Device characteristic data" are also to be met.
•
The content of these installation instructions is limited to the basic function of the devices and
their installation. The programming of the devices and re-configuration of the device
parameters is further described in the "Programming instructions SafePLC2". Detailed
knowledge and understanding of this information is a vital prerequisite for a new installation
or the modification of the device function or device parameters.
•
Commissioning (i.e. commencing operated as intended) is only allowed on compliance with
the EMC directive. The EMC test standards EN55011:2007 + A2:2007 and EN 61000-6-2:2005
are used as the basis.
•
For storage and transport the conditions according to EN 60068-2-6 in relation to the values
stated in "Tech. characteristic data" are to be met
•
It is imperative the wiring and connection instructions in the section "Installation" are
followed.
•
The applicable VDE regulations as well as other special
safety regulations for the specific application are to be followed.
•
The monitoring functions configured as well as their parameters and operators are to be
validated via a validation report.
•
The module's implementation is to be agreed with the responsible body (e.g. TÜV or BG).
•
Never install or place in operation damaged products. Please report any damage immediately
to the transport company.
•
Never open the housing and/or make any unauthorised modifications
•
Inputs and outputs for standard functions and the digital and analogue data transmitted via
communication modules are not allowed to be used for safety-related applications.
WARNING:
The usage of our devices contrary to the rules and conditions stated here can result in the injury or
the death of persons, as well as damage to the devices and machines connected!
This usage will also render void any claim under the warranty or any claim for claim damages against
the manufacturer.
PSC1-C-10 Installation manual V2.6
Version: 57E
Page 12 of 173