Access Code; Run Mode - VWR 5600 Series Operating And Maintenance Manual

Section 1
Installation and Start-Up

Access Code

An access code of 000 is required to access the Settings, Calibrate or
Configuration modes. If the access code is not set at the default '000', a
code must be entered to leave RUN mode. See Section 3 for instructions
on modifying the access code.

Run Mode

Run is the default mode for the freezer. The run mode will display the
cabinet temperature on the temperature display and 'SYSTEM OK' on the
message center under normal operating conditions. In addition, this mode
allows display of the following information:
LINE VOLTAGE
COMPENSATED VOLTAGE
HSHX TEMPERATURE (heat exchanger temperature)
This information is scrolled individually by pressing the right arrow key. In
each case, the message center returns to SYSTEM OK in 10 seconds if no
keys are pressed.
VWR International Model 5600 Series 1-11