Attach The Power Cord; Connect Unit To Electrical Power - VWR 5600 Series Operating And Maintenance Manual

Section 1
Installation and Start-Up

Attach the Power Cord

Connect Unit to Electrical
1-8 Model 5600 Series
Insert the power cord into the power inlet module. Place the retaining
bracket (P/N 195763) over the connector. Tighten retaining screws to
secure.
Figure 1-10. Power Cord Connection
Caution See the serial tag on the side of the unit for electrical specifications
or refer to the electrical schematics in this manual.
Power
The freezer should be operated on a dedicated grounded service. Check the
voltage rating on the serial tag of the unit and compare it with the outlet
voltage. Then, with the power switch turned off, plug the line cord into
the wall outlet.
First turn on the freezer power switch. Then open the lower front door by
grasping the bottom left corner. Locate the battery switch (Figure 1-5) and
turn it to Standby mode ( ). During initial freezer start-up, the system
battery may require charging and the Low Battery message may appear in
message center.
Caution Ensure the battery switch is turned to Standby mode ( ). The
rechargeable batteries require 36 hours to charge at initial start-up. A "Low
Battery" alarm may occur until the batteries are fully charged. Should a
power failure occur during the initial start-up period, the electronics will
have limited operation.
s
s
VWR International