EDER Titan 80 Pro Manual page 38

i
270900_00 | 02.2022
Notching
When the direction of fall of the tree to be felled has been determined,
you must cut the notch. The notch is made toward the direction of fall.
To cut the notch, proceed as follows:
Make the horizontal cut (3) and the wedge cut (2).
>
1 Intended felling direction
2 Wedge cut
3 Horizontal cut
Risk of injury due to tree breaking off prematurely!
Make sure that the top and bottom cuts of the notch meet exactly.
They must also not be too deep, as the tree will then break off
prematurely, which can lead to serious injuries.
> Make the top and bottom cuts of the notch meet exactly.
The depth of the notch should be 1/5-1/3 of the trunk diameter and the
notch angle 45°-60°.
4 Hinge
5 Holding wood
CAUTION
Titan 80 Pro 38