Inserting The Titan 80 Pro - EDER Titan 80 Pro Manual

270900_00 | 02.2022
Risk of injury from dead and falling limbs!
During inserting the safety wedge, limbs can fall off and cause
serious injuries. Therefore, observe the following:
> Insert the safety wedge into the tree trunk with minimal
vibration and watch the tree crown.
Risk of damage to the chainsaw due to jammed saw bar!
If a safety wedge is not used, the tree may lean in the direction of
the felling cut and jam the saw bar.
Place a safety wedge in the felling cut.
>

Inserting the Titan 80 Pro

When the felling cut has been made to 60% of the tree diameter and the
tree to be felled is secured with safety wedges, the Titan 80 Pro can be
inserted into the felling cut.
Widen the felling cut so that the device can be inserted at least
>
up to the marking on the spring steel plates.
Extend the wedge of the Titan 80 Pro until the device is firmly
>
seated in the wood.
WARNING
ATTENTION
Titan 80 Pro 42