Design And Function; Overview Of The Titan 80 Pro; Function - EDER Titan 80 Pro Manual

7
3
270900_00 | 02.2022

Design and function

Overview of the Titan 80 Pro

2
1 Encapsulated shaft drive
with taper roller bearing
2 Handle
3 Shaft with drive nut
4 Ratchet

Function

The Titan 80 pro is a felling tool designed exclusively for use in timber
harvesting. The Titan 80 Pro is inserted into the prepared felling cut in
the tree trunk. There is a mark on the spring steel plates up to which the
Titan 80 Pro must be inserted into the tree trunk. The rows of teeth on
the spring steel plates engage with the vertical wood fibres. The lifting
wedge made of special plastic is located between the spring steel
plates. With the help of the ratchet or an impact wrench up to 1300 Nm,
the shaft is driven and the lifting wedge made of special plastic is
pushed forward up to 16 cm. After felling, the lifting wedge can be
brought back to its original position. For big diameter trees, two Titan 80
Pro can be used side by side.
8
5
4
6
1
5 Lifting wedge made of
special plastic
6 Nameplate
7 Grease nipple 3x
8 Spring steel plates with
rows of teeth
Titan 80 Pro 36