Print speed
Selectable from levels 1 to 14 (Slow ~ Fast)
Default setting: level 13
Print speed is restricted by the settings for the number of head electrification divisions. The
maximum printing speed of 350 mm/s is only possible when 1 electrification division is selected.
The maximum printing speed when using 58 mm is 300 mm/s.
Depending on print conditions, such as print duty, print head temperature, and data transmission
speed, print speed is automatically adjusted, which may cause white lines due to intermittent print
(the motor sometimes stops). To avoid this, keep the print speed constant by setting it lower.
Column emulation mode
Standard mode (default setting)
48 column mode
This function is supported only on the ANK model.
Print density during multi-tone printing
Selectable from 70% to 130% (5% increment)
Default setting: 100%
Power supply output
Selectable from levels 1 to 3 low power load
Default setting: level 3
Paper width
80mm (default setting)
58mm
Interface selection
Fixed to UIB
Fixed to built-in USB
Fixed to Ethernet (Wi-Fi)
UIB/Bluetooth
Built-in USB auto switch
The entire interface is enabled (default setting)
Chapter 3 Advanced Usage
65
3