Overview Of The Basic System Test; How To Run The Basic System Test - HP Brio BA200 User Manual

NOTE
3 Basic System Test

Overview of the Basic System Test

Overview of the Basic System Test
The basic system test is performed after hardware detection. The
purpose of the basic system test is to verify the correct operation of the
main PC's hardware components. For each detected hardware
component, the test will confirm that:
The component is powered-on
•
The component has been initialized for use
•
The component is operating correctly under MS-DOS.
•
Unlike the advanced system tests, the basic system test is done
automatically and no user input or guidance is needed. This test phase
is suitable for all types of users, including novice and non-technical
users.
Most of the PC's components are tested during the basic system test.
To test each PC's component, use the advanced systems tests.

How to Run the Basic System Test

The basic system test is performed after the hardware detection phase.
To do the basic system test, follow these steps:
1 Start DiagTools. To learn how to do this, refer to chapter 1.
2 Follow the instructions on the screen to proceed with hardware
detection. Hardware detection is described in chapter 2.
3 You will then be invited to proceed with the basic system test. Press
and follow the instructions on your screen.
The screen image may become corrupted during the basic system test.
This is normal. Do not restart your system. The image will be restored
after the test is complete.
14 English