HP Brio BA200 User Manual page 54

Appendix A The Error Codes
0000h – 00FFh: System Error Codes
Code
0077h Periodic time update cycle not occurring.
0078h CMOS RAM checksum error detected.
0079h CMOS RAM fails to hold data.
0080h This test runs on EISA systems only
0081h EISA software NMI test failed
0082h EISA fail-safe timer test failed
0083h PCI System Bus scan test failed.
0084h Cannot access PCI devices through the
FIND_PCI_DEVICE call.
0085h Reading configuration space registers on
boundary conditions failed.
0086h Consistency checking of PCI configuration
space failed.
0087h GENERATE_SPECIAL_CYCLE check
failed.
0088h BIOS32 service directory integrity check
failed.
008Ah PCI stress test failed. Buffer data
mismatch.
42
Explanation
English
Details/Parts to Check
Real Time Clock (RTC) error.
Install new system board.
CMOS RAM error.
Install new system board battery.
If error persists, install new system board.
CMOS RAM error.
Install new system board battery.
If error persists, install new system board.
You attempted to run this test on a system that does
not have an EISA architecture.
Install new system board.
Install new system board.
BIOS or system board error.
Install new system BIOS.
If error persists, install new system board.
Install new BIOS or system board.
Install new BIOS or system board.
Install new BIOS or system board.
Install new system board.
BIOS error.
Install new system BIOS.
Check that the SCSI controller is correctly installed.