Required Tools; Connecting Ferrules; Connecting Twisted Wires/Solid Wires - Omron CK3W-GC 00 Series Hardware User Manual

5 Wiring
5-1-5

Required Tools

Use a flat-blade screwdriver to remove wires.
The recommended screw driver is as follows.
Model
SZF 0-0,4X2,5 Phoenix Contact
5-1-6

Connecting Ferrules

Insert the ferrule straight into the terminal hole.
It is not necessary to press a flat-blade screwdriver into the release hole.
After you make a connection, make sure that the ferrule is securely connected to the terminal block.
5-1-7

Connecting Twisted Wires/Solid Wires

Use the following procedure to connect the twisted wires or solid wires to the terminal block.
1
Press a flat-blade screwdriver straight into the release hole.
If you press in the screwdriver correctly, you will feel the spring in the release hole, and the
screw driver will begin to incline.
2
Leave the flat-blade screwdriver pressed into the release hole and insert the twisted wire or the
solid wire into the terminal hole.
Insert the twisted wire or the solid wire until the stripped portion is no longer visible to prevent
shorting.
5-4
Manufacturer
Ferrule
Release hole
Twisted wire/Solid wire
2
CK3M-series Programmable Multi-Axis Controller User's Manual Hardware (O036)
1
Flat-blade screwdriver