Ricoh M C251FW User Manual page 356

10. Troubleshooting
Message
RX Communication
Error
Scan (NW)
Disconnected
Scan (USB)
Disconnected
Server Connection
Failed
Server Response
Error
SCXXX
Set Correct Paper
354
Causes
A reception error occurred, and
the fax could not be received
correctly.
A scanned file could not be sent
because the Ethernet cable was
not connected properly.
The USB cable was
disconnected while scanning
from a computer.
A scanned file could not be sent
because the destination could
not be reached.
An error occurred in
communication with the server
before beginning transmission.
A fatal hardware error has
occurred, and the machine
cannot function.
The tray selected in [Select
Paper Tray] under [Fax Settings]
does not contain A4, Letter, or
Legal size paper.
Solutions
If possible, contact the sender of the fax
and ask them to resend it.
Reconnect the Ethernet cable properly,
and then try the operation again.
Reconnect the USB cable properly, and
then try the operation again.
Confirm that the destination is registered
correctly, and then try the operation again.
Confirm that the destination is registered
correctly, and then try the operation again.
If the problem could not be solved, contact
the network administrator.
Contact your sales or service
representative.
While the message is displayed, press [Set
Size]. A menu for changing the paper size
of the current tray appears.
Load A4/Letter/ Legal size paper in the
tray, and then select the corresponding
paper size.
Note that the paper size setting for the tray
under [Paper Settings] will be changed.
See page 246 "Paper Settings".