Advertisement
SINGLE DRIVE
Step 12 - 21 For Single Drive only. For Double Drive go to Step 22.
Screw 12 hooks into
the flyer.
Assemble the flyer unit.
Check the shape of the
nylon bearing on each
maid upright, wax the
dowel ends, then insert
into the correct hole.
Insert the drive belt
adjusting knob into the
maiden bar, turn until the
end just protrudes.
Check the angle of the nylon
bearings. Then secure the
maid uprights with screws and
washers. Do not overtighten.
The maid uprights may be
twisted to remove the bobbin.
Position the drawing pin
directly beneath the drive band
adjusting knob.
9
Advertisement
