Advertisement
DOUBLE DRIVE
Step 22 - 32 For Double Drive only. For Single Drive go to Step 12.
Screw 12 hooks into
the flyer.
Assemble the flyer unit.
Check the shape of the
nylon bearing on each
maiden upright, wax the
dowel ends, then insert
into the correct hole.
Insert the drive belt
adjusting the knob into
the maiden bar, turn until
the end just protrudes.
Check the angle of the nylon
bearings. Then secure the
maid uprights with screws and
washers. Do not overtighten.
The maid uprights may be
twisted to remove the bobbin.
Position the drawing pin
directly beneath the drive
band adjusting knob.
13
Advertisement
