Notices - GE NETWORX Series Installation And Start-Up Manual

XX.

NOTICES

(Applies to products which have the CE mark
attached)
DECLARATION OF CONFORMITY
Manufacturer's Name:
Manufacturer's Address: 1420 North Main Street
EU Representative:
Product Identification
Product:
Model Numbers:
Brand:
R&TTE Directive
See EMC and LVD tests below
EMC Directive
EN50081-1
EN50130-4
EN55022
EN60950
EN61000-3-2
EN61000-3-3
LVD Directive
EN 60950: 1999-4 3rd edition
Means of Conformity
We declare under our sole responsibility that this product
is in conformity with Directive 1999/5/EC (R&TTE);
Directive 73/23/EEC (LVD); and Directive 89/336/EEC
(EMC) and based on test results using (non)-harmonized
standards in accordance with the Directives mentioned.
Additional Tests
This equipment has been tested and found to comply
with the following standards (which are no longer
required for compliance).
74
Caddx Controls
Gladewater Texas 75647
Interlogix Europe
NetworX
NX-8E
CADDX
Network Compatibility Declaration
We declare under our sole responsibility that this product
is designed to work with the networks in the countries
marked with a check ( ) and may have interworking
problems with the countries that are not checked. Due to
the inherent differences in the individual PSTNs, certain
software settings may need to be adjusted on a country-
to-country basis. If it is desired to use this equipment on
a network other than the one on which it was originally
installed, you should contact your equipment supplier.
( ) Austria
( ) Belgium
( ) Denmark
( ) Finland
( ) France
( ) Germany
( ) Greece
( ) Iceland
( ) Ireland
( ) Italy
Telecom Approval Notice
This equipment has been approved in accordance with
the Council Decision 98/482/EC for pan-European, single
terminal connection to the public switched telephone
network (PSTN). However, due to the differences
between the individual PSTNs provided in different
countries, the approval does not, of itself, give an
unconditional assurance of successful operation on every
PSTN network termination point. In the event of
problems, you should contact your equipment supplier in
the first instance.
Electrical Requirements
This device automatically adjusts to voltages within the
range of 230 V 50/60 Hz.
Fuse: Type T 200mA 250 VAC
(_) Liechtenstein
( ) Luxembourg
( ) Netherlands
( ) Norway
( ) Poland
( ) Portugal
( ) Spain
( ) Sweden
( ) Switzerland
( ) United Kingdom
NX-8E CONTROL