GE NETWORX Series Installation And Start-Up Manual page 27

LOCATION 47 - AUXILIARY OUTPUT #1, EVENT AND TIME (2 segments, numerical data)
Segment 1: Use the chart on page 25 to select the event that will activate Auxiliary Output 1.
Segment 2: Program the timing from 0-255 (minutes or seconds, depending on data programmed in
Segment 1, Location 46). Programming a "0" makes the output follow the event.
LOCATION 48 - AUXILIARY OUTPUT #2, EVENT AND TIME (2 segments, numerical data)
Segment 1: Use the chart on page 25 to select the event that will activate Auxiliary Output 2.
Segment 2: Program the timing from 0-255 (minutes or seconds, depending on data programmed in
Segment 2, Location 46). Programming a "0" makes the output follow the event.
LOCATION 49- AUXILIARY OUTPUT #3, EVENT AND TIME (2 segments, numerical data)
Segment 1: Use the chart on page 25 to select the event that will activate Auxiliary Output 3.
Segment 2: Program the timing from 0-255 (minutes or seconds, depending on data programmed in
Segment 3, Location 46). Programming a "0" makes the output follow the event.
LOCATION 50- AUXILIARY OUTPUT #4, EVENT AND TIME (2 segments, numerical data)
Segment 1: Use the chart on page 25 to select the event that will activate Auxiliary Output 4. .
Segment 2: Program the timing from 0-255 (minutes or seconds, depending on data programmed in
Segment 4, Location 46). Programming a "0" makes the output follow the event.
Table XI-1 AUXILIARY OUTPUT EVENT SELECTION
DATA EVENT
/ Burglary Alarm
0
/ Fire Alarm
1
/ 24 Hour Alarm
2
/ Trouble Alarm
3
/ Tamper Alarm
4
5 Yelping Siren (Burglary)
6 Temporal Siren (Fire)
7 Any Siren
8 Any Bypass
9 AC Fail
10 Low Battery
/ Duress
11
/ Aux 1 Keypad Zone
12
/ Aux 2 Keypad Zone
13
/ Panic Keypad Zone
14
15
Keypad Tamper
/ Autotest
16
17 Alarm Memory
˜ Events 49 & 50 require NX-408, NX-416, or NX-448 wireless receivers to operate.
/ If set to follow condition, these events will be 1 second.
Notes: When Event 48 is programmed, it is possible to program a user code's authorization to select which output(s)
a particular code will activate. When LED 8 is on for an authorization, then LEDs 1- 4 correspond to that code
activating outputs 1 - 4 respectively. (See programming the LED keypads on page 8.)
NX-8E CONTROL
DATA EVENT
18 Entry
19 Exit
20 Entry or Exit
21 Armed State
22 Disarmed State
23 Ready
24 Not Ready
25 Fire
26 Fire Trouble
27 Chime
/ Expander Trouble
28
29 Dynamic Battery Test Time
30 Open Period
31
Closed Period
32 Listen-In
33
Line Seizure
34 Ground Start
35 Fail To Communicate
DATA EVENT
36 Telephone Line Fault
37 Program Mode
38 Download In Process
39 Ground Fault
40 Short Circuit (Over-current)
41 Box Tamper
42 Siren Tamper
43 Any Open
44 Any Short
Any Fault (Open/ Short on
45
Non-Fire Zone)
/
46 Any Alarm
47 Beeping Keypad
/
48 Code Entry (See note below)
˜
49
Key FOB Function 1
/
˜
50 Key FOB Function 2
/
69
Forced Door Alarm
70 Forced Door Restore
25