Table of Contents
Advertisement
Electrical Requirements
• Oven requires a separate, grounded 4-wire, 240V (AC), 30 amp (single ovens) and 50 amp (double ovens) service with its own
circuit breaker.
• Wire sizes and connections must conform with the rating of the appliance and to the requirements of the National Electrical
Code, ANSI/NFPA-70 – latest edition, or Canadian Electrical Code, CSA C22.1-1982 and C22.2 No. 01982 – latest edition, and all
local codes and ordinances.
• Oven must be connected to the proper electrical voltage and frequency as specifi ed on the model/serial rating plate (located
inside the vent ont the right sode of the oven).
• Oven must be connected to grounded metal permanent wiring system. Check with a qualifi ed electrician to make sure the oven
is properly grounded.
• Do not ground to a gas pipe.
• Do not use an extension cord with this appliance, because this may result in electrical shock or other personal injury.
• This unit is equipped with a No. 10 ground wire in the conduit.
• The electrical conduit must be kept to the top left for a fl ush installation. Never cut the conduit.
• Connect the fl exible armored cable directly to 4-wire, 240V household service. If codes permit and separate grounding wiring is
used, we recommend that a qualifi ed electrician determine the grounding path and that the wire gauge is in accordance with
local codes.
• Junction boxes installed on rear wall directly behind oven must be recessed.
• A UL-Listed conduit connector must be provided at the junction box.
• Do not install a fuse in the neutral or grounding circuit. We recommend a time-delayed fuse or circuit breaker. Connect directly to
the fused disconnect (or circuit breaker box) through fl exible armored, or non-metallic sheathed, copper cable (with grounding
wire).
WARNING
FIRE OR ELECTRICAL SHOCK HAZARD
DO NOT use an extension cord with this
appliance. Such use may result in fi re, electrical
shock or other personal injury.
7
Advertisement
Table of Contents
