Table of Contents
Advertisement
Cutout Dimensions
i n .
"
2 4
) m
1 - 1
c m
. 0
( 3 .
( 6 1
3 "
( 7 .
6 c
Gas inlet
location
2 8
- 5 /
( 7 2
8 "
. 7
c m
)
30"W. Cutout
8
All manuals and user guides at all-guides.com
/ 2 "
8 c
m )
Electrical outlet to be located
in shaded area on rear wall
m )
3 "
( 7 .
6 c
m )
d i a
3 0
.
- 5 /
( 7 7
8 "
. 8
c m
)
1 7
( 4 3
"
. 2
c m
) m
i n .
3 0
( 7 6
"
R e
. 2
c o
c m
m m
)
e n
d e
d
Clearance Dimensions
Note: Door handle of oven should be 36"
(91.4 cm) above the floor.
Note: The grounded electrical socket should
be placed above or below cutout(s).
CAUTION
To prevent possible damage to cabinets
and cabinet finishes, use only moisture
resistant materials and finishes that will
withstand temperature up to 190°F
(88°C). When cabinets are covered with
laminates, an appropriate heat-resistant
adhesive must be used. Consult your
manufacturer for proper specifications.
Electrical & Gas Requirements
Electrical Requirements
These ovens are designed specifically for
Check your national and local codes
natural gas or liquid propane (LP) gas. It is
regarding this unit. These ovens require
shipped from the factory adjusted for use
3-wire, 120 VAC/60 Hz. See "Connecting
with natural or propane (LP) gas. Before
Gas & Electrical" section for grounding
beginning installation verify that the
instructions.
model is compatible with the intended
gas supply.
WARNING
Manual shut-off valve:
Electrical shock hazard.
This installer-supplied valve must be installed
in the gas service line before the appliance
To avoid the risk of electrical
in the gas stream and in a location where it
shock, personal injury or death;
can be reached quickly in the event of
verify electrical power is turned
an emergency.
off at the breaker box and gas supply is
turned off until the oven is installed and
In Massachusetts:
ready to operate, installation by an
manual valve must be installed in the gas
authorized installer only.
supply line to the appliance.
Gas Connection
IMPORTANT: Any conversion required
The gas supply (service) line must be the
must be performed by your dealer or a
same size or greater than the inlet line of the
qualified licensed plumber or gas service
appliance. This oven uses a 1/2" (1.3 cm) ID
company. Please provide the service person
NPT (Sch40) inlet. Sealant on all pipe joints
with this manual before work begins.
must be resistive to LP gas.
9
CAUTION
Burn hazard.
To avoid risk of personal injury;
the use of cabinets for storage
above the appliance may result
in a potential burn hazard. Combustible
items may ignite, metallic items may
become hot and cause burns.
A "T" handle type
Advertisement
Table of Contents
