Attaching The Cabinet Door Handles; Mounting The Cabinet Doors To The Cart; Attaching The Lid Handle; Securing The Lid Stopper - Pit Boss PB1000XL/SC3 Assembly And Operation Manual

6. ATTACHING THE CABINET DOOR HANDLES

Parts Required:
2 x Cabinet Door (#18 & #19)
2 x Cabinet Door Handle (#15)
Cabinet Door Bezel (#16)
4 x
Installation:
• Remove the pre-installed screws from the cabinet door handle. From
the rear of the cabinet door, insert one screw so that it protrudes to the
front. Add a cabinet door bezel on the screw, then hand-tighten the
screw (from the rear) into the cabinet door handle. Continue to secure
the handle by inserting a screw into the other side and tightening.
• Repeat same installation for second cabinet door handle.

7. MOUNTING THE CABINET DOORS TO THE CART

Installation:
• Align the left cabinet door with the front of the cart. Insert the bottom
pin into the pivot hole on the left side of the bottom shelf, then push
down on the locking-loaded top pin, and lock into the hole on the
main barrel brace.
IMPORTANT: The cabinet door should swing freely once installed, and
line up with the door stopper and door magnet. If unlevel, ensure
the top and bottom pins of the cabinet door are inserted correctly.
• Repeat same installation for second cabinet door on the right side.

8. ATTACHING THE LID HANDLE

Parts Required:
1 x Lid Handle (#10)
2 x Lid Handle Bezel (#9)
Installation:
• Remove the pre-installed screws from the lid handle. From inside the
barrel lid, insert one screw so that it protrudes to the outside. Add a
bezel on the screw, then hand-tighten the screw (from the inside) into
the lid handle. Repeat same installation for other end of lid handle.

9. SECURING THE LID STOPPER

Parts Required:
1 x Lid Stopper (#5)
Installation:
• Secure the lid stopper onto the top of the main barrel using the pre-
installed screw on the top of the main barrel.
6
18 & 19
16
15
16
7
8
10
9 9
9
5
9