Table of Contents
Advertisement
2. INSTALLING THE BOTTOM SHELF
Parts Required:
1
x
Bottom Shelf (#19)
Screw (#A)
4
x
4
x
Locking Washer (#C)
Washer (#B)
4
x
Installation:
•
From underneath, secure the bottom shelf to all each leg using a
screw, locking washer, and washer. Ensure the flat surface of the shelf
is facing up.
•
Once the shelf is secure, carefully lift the grill into an upright position.
3. SECURING THE LID STOPPER
Parts Required:
1
x
Lid Stopper (#3)
Installation:
•
Secure the lid stopper onto the top of the main barrel using the pre-
installed screw on the top of the main barrel.
4. ATTACHING THE LID HANDLE
Parts Required:
1
x
Lid Handle (#11)
Lid Handle Bezel (#10)
2
x
Installation:
•
Remove the pre-installed screws from the lid handle. From inside the
barrel lid, insert one screw to protrude to the outside. Add a bezel on the
screw, then hand-tighten the screw (from the inside) into the lid handle.
•
Repeat same installation for other end of lid handle.
5. PLACING THE GREASE BUCKET
Parts Required:
Grease Bucket (#14)
1
x
Installation:
•
Unscrew the six screws along the outside of the hopper that secure
the hopper safety screen to the interior, and remove the safety screen
to access the grease bucket. Replace the hopper safety screen, and re-
install the six screws to secure. Note illustration 5A.
•
Place the grease bucket on the spout hook on the end of the main
barrel. Ensure it is level to avoid grease spills. Note illustration 5B.
8
2
19
3
3
4
11
10
5A
5B
10
14
Advertisement
Table of Contents
