Assembly Preparation; Assembly Instructions; Mounting The Legs To Main Barrel - Pit Boss PB1100PS1 Assembly And Operation Manual

Wood pellet grill & smoker

Table of Contents

Available languages

Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister

pack after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill

before assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt

to assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss Customer Service for parts: Monday

through Sunday, 4am - 8pm PST (EN/FR/ES).

service@pitboss-grills.com | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135

IMPORTANT: To ease installation and avoid injury, use two people when assembling this appliance.

Tools required for assembly: screwdriver and level. Tools not included.

IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws

completely until all screws for that step have been installed. Hardware combination involving a locking washer and

washer should be installed with the locking washer closest to the head of the screw.

1. MOUNTING THE LEGS TO MAIN BARREL

Parts Required:

Main Barrel / Hopper Assembly (#10)

Support Leg for Caster (#16)

Support Leg (#17)

12 x

Screw (#A)

12 x

Locking Washer (#C)

12 x

Washer (#B)

Installation:

•

Place a piece of cardboard on the floor to prevent scratching the unit.

Lay the main barrel on its side, hopper end pointed upward, on the

cardboard.

•

Mount one support leg (#17) to the floor end of the main barrel using

three screws, locking washers, and washers, through the three pre-drilled

holes. Install screws from the inside of the main barrel. Repeat installation

for second support leg. Note illustration 1A.

Mount one support leg for caster (#16) to the hopper end of the main

•

barrel using three screws, locking washers, and washers, through the

three pre-drilled holes. Install screws from the inside of the main barrel.

Repeat installation for second support leg for caster. Note illustration 1B.

NOTE: Fasten screws of the support legs only half-way to allow easier

installation of bottom shelf in next step.