Select Downlink Antenna - Yaesu DR2XLAN Operating Manual

After completing the input frequency, the input popup screen automatically disappears and the input frequency
is set.
Input the downlink frequency in the same way.
Touch [ Back ] to return to the operation mode screen, and touch [ B SETUP ] on the bottom of the screen to
display the CH-B frequency set up screen, then set the uplink and downlink frequency.
Even if the CH-A and CH-B uplinks are set to different frequencies, setting the downlink to the same frequency,
makes it possible for all members to hear the conversation at the same downlink frequency whatever the uplink
frequency is used.

Select downlink antenna

Normally, downlink of CH-A outputs to the CH-A TX Antenna Terminal and the downlink of CH-B outputs to the
CH-B TX Antenna Terminal. Both CH-A and CH-B downlinks may output to the CH-A TX Antenna Terminal.
This setting allows to operating the downlink frequency with the same antenna.
How to set up the downlink antenna terminal:
1 Touch [ B SETUP ] to display the CH-B frequency set up screen.
The setup mode screen will appear.
2 Press "DOWN LINK" in the CH-B frequency set up screen, "DOWN
LINK" will be changed to "DOWN LINK TO ANT-A" and CH-B downlink
signal will be output to CH-A.
Since the DR-2X/DR-2XE has only one transmitter, even if the downlink frequency is set separately, the signal will not
be transmitted simultaneously.
12
S E T U P R X x . x x T X . x
P A N E L x . w w w D S P .
S E T U P R X x . x x T X . x
P A N E L x . w w w D S P .
DOWN L I N K TO ANT-A
DR-2X / DR-2XE Operating Manual
 9 4 0
L A N . .
 4 4 0
 9 4 0
L A N . .
 4 4 0