Table of Contents
Advertisement
Key mode
Set the function "prt 1, 2 or 3".
When the PRINT key is pressed while the weight data is stable (the stability mark is
on), the balance transmits the data. When the data is transmitted, the display will blink
one time.
Auto-print mode A
Set the function "prt 2".
The balance transmits the weight data when the display is stable (the stability mark is
on) and the data is greater than +4d (of the lowest range for EW-i series).
The next output can be obtained after the display returns below +4d.
Auto-print mode B
Set the function "prt 3".
The balance transmits the weight data when the display is stable (the stability mark is
on) and the data is greater than +4d (of the lowest range for EW-i series) or less than -
4d.
The next output can be obtained after the display returns between -4d and +4d.
9-4. Command mode
In the command mode, the balance is controlled by commands that come from the
personal computer and so on.
Command list
Command to request the current weight data.
Command
Reply
Command to zero or tare the balance (same as the RE-ZERO key).
Command
Reply
Command to change the weighing units (same as the MODE key).
Command
Reply
Q C
L
R
F
S T , + 0 0 1 2 3 4 . 5
Z C
L
R
F
Z C
L
R
F
U C
L
R
F
U C
L
R
F
24
g C
L
R
F
Advertisement
Table of Contents
