Network Connector; Validating Network Discovery; Multiple Subnet Support - Matrox QuadHead2Go Q185 User Manual

LED color
No LED (black)
Green (solid)
Green (slow blink)
Green (fast blink)
Amber (solid)
Amber (slow blink)
Red (solid)

Network connector

The network connectors on your QuadHead2Go products use LEDs to
provide information on the network activity and presence. The following
describes the different network connector LEDs.
LED color
No LED (black)
Green (fast blink)
Green

Validating network discovery

QuadHead2Go Series devices are initially assigned their IP addresses through DHCP (Dynamic Host
Control Protocol). After connecting your devices, we recommend verifying that all of your devices are
discovered by the network. For more information, contact your network administrator.

Multiple subnet support

QuadHead2Go Series devices that are in the same subnet are detected through the UPnP (Universal
Plug and Play) protocol. If your devices are in different network subnets, you need to validate network
discovery in each subnet separately. For more information on using different subnets, contact your
network administrator.
After validating your connection setup, install your software.
A
Device isn't powered.
Device is active.
Device is rebooting.
Device is selected.
(I-am-here feature.)
Firmware update in progress.
No network detected.
Device has detected a fatal error. Try powering your device off and
on. If, after restarting your device, the LEDs are still red, contact your
vendor for technical support
Network activity
No network activity detected. —
Network activity detected.
—
B
—
Device is active. No errors.
Input or output signal doesn't
match configuration.
—
No input signal detected.
Firmware update in progress.
(see "Customer support", page
Network
activity
Network presence
—
1 Gbps
Matrox QuadHead2Go Series – User Guide 26
46).
Network
presence