Tao Motor G 200 Owner's Manual page 65

NOTICE
To tighten drive chain,
A. Insert an appropriate sized bolt through the sprocket into axle carrier.
(M10X60 Bolt found in tool kit supplied with ATV)
B. Shift the transmission into the Neutral position.
C. Push vehicle forward slightly.
D. When proper chain slack is achieved remove adjuster bolt.
To loosen drive chain,
A. Insert an appropriate sized bolt through the sprocket into axle carrier.
(M10X60 Bolt found in tool kit supplied with ATV)
B. Shift the transmission into the Neutral position.
C. Push the vehicle rearward slightly.
D. When proper chain slack is achieved remove adjuster bolt
4. Tighten carrier housing pinch bolts and nuts.
5. Tighten brake caliper mounting bracket bolt.
Drive chain slack:
5.0-10.0 mm (0.19-0.39 in)
Tightening Torques:
21 Nm (15 ft/lb)
Cleaning Lubricating Drive Chain
The drive chain must be cleaned and lubricated at the intervals specified in the periodic maintenance and lubrication chart, otherwise it
will quickly wear out, especially when riding in dusty or wet areas.
Service the drive chain as follows:
1. Remove all dirt and mud from the drive chain with a brush or cloth.
2. Spray chain lubricant on the entire chain, making sure that all side plates and rollers have been sufficiently oiled.
The drive chain must be lubricated after washing the ATV or riding in the rain or wet areas.
The drive chain slack is adjusted by the rota-tion of the carrier/housing forward and rear wards .
Chain Adjustment Bolt M10X60 Bolt
55