Gear Box Oil - Tao Motor G 200 Owner's Manual

GEAR BOX OIL

The Gear box case must be checked for oil leaks before each ride. If any leakage is found have a Tao Motor dealer perform repairs. Gear
box oil must be changed at the intervals specified in the maintenance and lubrication chart.
To change gear box oil
1. Place ATV on level surface and set parking brake.
2. Remove right side foot rest.
3. Remove exhaust pipe assembly.
4. Place an oil pan under the gear box oil drain plug to collect used oil.
5. Remove the gear box oil filler plug (17mm) and its washer from the gear box (#2).
6. Remove the gear box oil drain plug (17mm) and its washer (#1).
7. Reinstall gear box drain plug and washer to specified torque 21.5 Nm (2.15m.kgf, 15.5 Ft.lbf)
8. Fill gear box oil to 600ML of SAE 80 W/90 gear oil.
9. Re-install exhaust pipe assembly and gasket.
10. Re-install gear box fill plug and washer.
11. Re-install foot rest.
12. Check for oil leaks.
TIP
To prevent burns, avoid touching hot exhaust system. Wait till engine assembly is cold before any service
is performed.
Always replace exhaust gasket when removing exhaust pipe. Never reuse exhaust gasket.
49
1. Gear Box Oil Drain Plug (17mm)
2. Gear Box Oil Fill Plug (17mm)