Table of Contents
Advertisement
11.3.1 ATIS Code Setup (GX1400GPS/E only)
[
] "SETUP" "ATIS SETUP" "ATIS CODE"
1.
2. Press the [◄] or [►] key to select the first number
of your ATIS, then press the [SELECT] soft key to
step to the next number.
3. Repeat step 2 to set your ATIS (ten digits).
4. If a mistake was made entering in the ATIS, press
the [▲]/[▼]/[◄]/[►] key to select "←" or "→", press
the [SELECT] soft key until the wrong number is
selected, then perform step 2.
5. When finished programming the number, press the
[FINISH] soft key. The Radio will ask you to input
the ATIS number again. Perform steps 2 through
4 above.
6. After the second number has been input, press
the [FINISH] soft key to store the ATIS number in
memory.
7. Press the [OK] soft key to return to radio operation.
11.3.2 ATIS CH Group
The GX1400GPS/E has the capability to turn on and off the ATIS feature for
each channel group.
[
] "SETUP" "ATIS SETUP" "ATIS GROUP"
1.
2. Press the [▲] or [▼] key to select the channel group
(International, Canadian*, or USA) you wish to
change the setting, and press the [SELECT] soft key.
(*: Depending on the region setting.)
3. Press the [▲] or [▼] key to select "ON" or "OFF".
4. Press the [ENTER] soft key to save the store setting.
70
ATIS CODE INPUT
1st:
----------
BACK
FINISH SELECT
ATIS CODE INPUT
1st:
* * * * * * * * * *
2nd:
-
- - - - - - - - -
BACK
FINISH
SELECT
ATIS CODE INPUT
STORED CODE
9366901230
OK
ATIS GROUP
USA
OFF
INTL
OFF
CAN
OFF
BACK
SELECT
USA
OFF
ON
BACK
ENTER
Advertisement
Table of Contents
