Table of Contents
Advertisement
Group MMSI:
Group MMSI numbers are not assigned by the FCC or other organizations
licensed to assign ship MMSI numbers.
The first digit of a group MMSI is always set to "0" by the international rules.
All Standard Horizon radios are preset so when programming a group MMSI
the first digit is set to "0".
The USCG recommends programming the MID of a ships MMSI into the
second, third and fourth digits of the group MMSI as it denotes the area
the ship is located in.
The last 5 digits are decided upon by persons in the group. This is an impor-
tant step as all radios in the group must contain the same group MMSI so
they can be contacted by each other. There is a chance that another group
of vessels may program in the same group MMSI. If this happens, simply
change one or more of the last 5 digits of the group MMSI.
[
] "SETUP" "DSC SETUP" "GROUP DIR."
1.
2. Press the [▲] or [▼] key to select "ADD", then
press the [SELECT] soft key.
3. Press the [▲] or [▼] key to select "NAME:", then
press the [SELECT] soft key.
4. Press the [▲] or [▼] key to scroll through the first
letter of the group name you want to reference in
the directory.
5. Press the [SELECT] soft key to store the first letter
in the name and step to the next letter to the right.
6. Repeat steps 4 and 5 until the name is complete.
Press the [ ►] key to move to the next space if you want to enter a blank
space in the name.
If a mistake was made entering in th name, press the [◄ ] or [►] key repeat-
edly until the wrong letter is highlighted, then press the [▲] or [▼] key to
correct the entry.
7. After the twelfth letter or space has been entered, press the [FINISH] soft
key to return to the previous screen.
GROUP DIR.
ADD
EDIT
DELETE
BACK
SELECT
ADD
NAME:
-------------
GROUP MMSI:
0--------
BACK
SELECT
ADD
NAME:
Y
-----------
BACK
FINISH
SELECT
47
Advertisement
Table of Contents
