Table of Contents
Advertisement
7. Press the [▲] or [▼] key to select the operating
channel you want to communicate on and press
the [SELECT] soft key.
8. Press the [YES] soft key to transmit the group
call signal.
9. After the group call is transmitted, the transceiver will switch to the channel
selected in step 7, without changing the display. To change the display,
press the [QUIT] soft key.
10. Listen to the channel to make sure it is not busy, then key the microphone
and call the other vessels you desire to communicate with.
10.5.3 Receiving a Group Call
1. When a group call is received, the transceiver will produce a ringing alarm
sound. (DSC BEEP needs to be enabled to hear alarm.)
The display will show the MMSI (or name) of the vessel transmitting the
group call.
2. Press any key to stop the alarm.
3. To immediately switch to requested channel, press
the [ACCEPT] soft key.
If a key is not pressed for thirty seconds after a
group call is received, the transceiver will automati-
cally switch to the requested channel for you to
monitor communications.
4. Press the [PAUSE] soft key to suspend the
acknowledgement.
Press the [RESUME] soft key to resume the
acknowledgement.
5. If you want the radio to stay on the channel you were on before receiving
the group call, press the [QUIT] soft key.
50
INTERSHIP CH
CH:06
CH:08
CH:09
CH:10
BACK
MANUAL SELECT
GROUP
036690155
CATEG: ROUTINE
CH: 08
Transmit a Call?
YES
NO
RX GROUP
YAESU
CATEG: ROUTINE
CH: 08
SINCE: 00:05
ACCEPT
PAUSE
QUIT
08
BUSY
M
GROUP PAUSE
RESUME
QUIT
USA
25W
A
C
Advertisement
Table of Contents
