10.6.2 Receiving a Position Request
When a position request call is received from another vessel, a ringing alarm
will sound and "POS REQUEST" will be shown in the LCD.
1. When a position request call is received, the trans-
ceiver will transmit your position to the vessel who
requested it.
2. To exit from position request display, press the
[QUIT] soft key.
10.6.3 Setting up the Position Request Ringer
The transceiver has the capability to turn off the position request ringer.
[
] "SETUP" "DSC SETUP" "DSC BEEP"
1.
2. Select "POS REQUEST" with the [▲] or [▼] key,
then press the [SELECT] soft key.
3. Press the [▲] or [▼] key to select "OFF", then
press the [ENTER] soft key.
4. Press the [16/S] key or press the [CLR] soft key to return to radio opera-
tion mode.
If you wish to return to enabling the ringer tone, just repeat the above procedure,
pressing the [▲] or [▼] key to select "ON" in step 3 above.
10.7 POSITION REPORT
The feature is similar to the position request, however instead of requesting
a position of another vessel this function allows you to send your position to
another vessel. In order to send your position you need to have a GPS receiver
connected or to have manually input your position. See section "9.9 MANUAL
INPUTTING OF THE GPS LOCATION."
RX POS REQUEST
YAESU
POS REPLY
SINCE: 00:05
[
Transmitted
QUIT
DSC BEEP
INDIVIDUAL
ON
GROUP
ON
ALL SHIPS
ON
POS REQUEST
OFF
BACK
SELECT
POS REQUEST
OFF
ON
BACK
ENTER
]
55