5.1
DIAGNOSTIC PORT
The diagnostic port is located behind the battery cover
at the near the ground control station as shown below.
The MDI (Multifunction Digital Indicator) and the JLG
Hand-Held Analyzer can be connected at this port..
Figure 5-1. Diagnostic Port
Analyzer Display
Escape Key
To return home or
access previous menu
Up & Down Arrow Keys
Value Selector
3121656
SECTION 5. JLG CONTROL SYSTEM
5.2
To Connect the Hand Held Analyzer:
NOTE: The cable has a four pin connector at each end of the
m en u:
HELP:
PRESS ENTER
Figure 5-2. Hand Held Analyzer
SECTION 5 - JLG CONTROL SYSTEM
HAND HELD ANALYZER
1. Connect the four pin end of the cable supplied
with the analyzer, to the diagnostic port (refer to
Figure 5-1.) and connect the remaining end of the
cable to the analyzer.
cable; the cable cannot be connected backwards.
2. Power up the Control System by turning the lower
key to the platform position and pulling both
emergency stop buttons on.
Stores and selects Top Level, Sub Level,
Left & Right Arrow Keys
Used to move between Top Level, Sub
Level, and item menus
Enter Key
and item menus
5-1