Brakes - Manual Disengage Procedure - Oshkosh JLG 1930ES Service Maintenance Manual

Brakes - Manual Disengage Procedure

1. Chock wheels or secure machine with tow vehicle.
2. Ensure battery disconnect switch is in to the "OFF"
position.
3. Remove the two Cover Bolts and Brake Cover.
4. Insert the Cover Bolts into the two Disengage
Holes in the brake housing.
5. Tighten down the Cover Bolts and the brake on
that drive motor will disengage.
6. Repeat this procedure on opposite wheel drive.
With both drive motor brakes now disengaged,
the machine can be moved manually.
7. After towing is complete, chock wheels and
remove Cover Bolts from Disengage Holes.
8. Reinstall Brake Cover.
3121656
1. Brake Cover
2. Cover Bolts
Figure 3-2. Disengage Procedure
SECTION 3 - CHASSIS & SCISSOR ARMS
3. Disengage Holes
AFTER THE MACHINE IS TOWED, THE DISENGAGE BOLTS MUST
BE REMOVED FROM THE BRAKE DISENGAGE HOLES. THE
BRAKES CANNOT BE ENGAGED WITH THE DISENGAGE BOLTS IN
THE BRAKE DISENGAGE HOLES. THIS WILL CAUSE THE MACHINE
TO ROLL WHEN PARKED ON AN INCLINE.
CAUTION
3-5